Power UNITS FOR LIFT TABLE 1
Basic Description
This power unit is created exclusively to the little lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit is extensively utilized while in the marketplace of logistic gadgets including minifork lift, scissors lift and ariel working platforms. The lower-ing movement is managed through the solenoid valve with the pace controlled from the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is created exclusively to the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as velocity controlled from the adjustable needle valve. When the lift rises to a substantial positoin, however the power provide is cut, the decreasing movement is managed through the manual override function.
Power UNITS FOR LIFT TABLE three
Basic Description
This energy unit is made solely for your big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve along with the pace managed by a stress compensated flow handle valve.
Power UNITS FOR LIFT TABLE four
Standard Description
This energy unit is built solely to the significant lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve and also the velocity controlled from the adjustable needle valve. Once the lift rises to a higher positoin, but the energy supply is reduce, the decreasing motion is managed from the guide override perform.
Unique Notes
one. This power unit is of S3 duty cycle, which may only function intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean the many hydraulic components concerned prior to installation of the energy unit.
three. Viscosity of the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
four. Oil altering is required immediately after the original a hundred operation hrs,afterwards once every single 3000 hrs.
five. The energy unit proven is created to be mounted vertically.